CAD Audio U37 Manuel d'instructions télécharger pdf

U37 USB Studio Recording

Microphone

The U37 is a side-address microphone. When recording, speak or

play into the side of the mic that has the CAD logo.

The U37 has two switches on the front. The ﬁ rst switch allows you

to decrease the sensitivity of the microphone so the sound quality

is clear for extremely loud sounds. For example, the switch should

be in the “-10” position for loud voices, percussion and other high

sound pressure level devices. The “0” position should be used for

normal voices and string instruments. If the recording is unclear or

distorted set the switch to “-10” and re-record.

The second switch on the U37 is designed to reduce pickup of

deep-bass sounds. The switch should be in the “Normal Bass”

mode in most cases. However, if you want to remove wind noise,

ventilation noise, or decrease the low frequencies in a recording,

the switch should be in the “Bass Reduction” position.

Normal

Bass

Reduction

Bass settings

Before using the U37 in your favorite audio or communications

application you must conﬁ rm that the computer’s operating

system recognizes the U37.

Windows XP recognition instructions

1. Plug the U37 into the USB port on the computer.

(When using a USB hub, check with the hub manufacturer to

be sure the hub supports a device such as a microphone. Plug

the U37 directly into the computer’s powered USB port for

optimal performance.)

2. Allow 30 to 60 seconds for the system software to recognize

the U37. (A series of bubbles will appear by the Windows

toolbar to notify you of a new device.)

3. In the Start Menu, select Control Panel.

4. Select “Sounds, Speech, and Audio Devices”.

5. Select “Sounds and Audio Devices”.

6. Select the “Audio” tab. Conﬁ rm that under the “Sound

recording” section the “C-Media USB Audio Device” is

selected. (The “Sound playback” should remain your usual

sound output device).

7. Select the “Volume” tab under the Sound recording heading

and select “Advanced Controls” in the Options menu of this

window.

8. Click the “Advanced” button to open the “Advanced Controls

for Wave In” window. Depending upon your system, you

might have the option of selecting “1 AGC” or “Mic boost”.

Checking this option will signiﬁ cantly increase the sensitivity

of the microphone. Use this for recording softer sounds. If you

experience distortion when recording louder sounds, try

unchecking this option.

9. Launch your audio recording software.

10. Position the U37 approximately 4 to 6 inches from the sound

source for best results.

11. Locate the preferences in your audio program and select

the “C-Media USB Audio Device”. Adjust the input level in this

program so that the audio signal is not distorted.

12. Enjoy your CAD U37 USB Studio Recording Microphone.

(Default playback device)

1 2

Résumé du contenu

Page 1 - Microphone

U37 USB Studio Recording MicrophoneThe U37 is a side-address microphone. When recording, speak or play into the side of the mic that has the CAD logo.

Page 2 - 800-762-9266 www.cadmics.com

Mac OSX recognition instructions1. Plug the U37 into the USB port on the computer. (When using a USB hub, check with the hub manufacturer to be su

Commentaires sur ces manuels

Pas de commentaire

CAD Audio U37 Manuel d'instructions

Naviguer en ligne ou télécharger Manuel d'instructions pour Microphones CAD Audio U37. CAD Audio U37 microphone Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Microphones CAD Audio U37